Under the hood systems

Filling pipe for Clutch Release System

The filling pipes for Clutch Release System ensure the filling of the high pressure line.

• Raw Material: mainly PP
• Corrugated straight or bent tubes answering to routing requirements
• Equipped with specific connections (grommets, grease, caps) and protection solution if needed

High pressure pipe for Clutch Release System

The high pressure pipes for Clutch Release System ensure the transmission of the impulse given by the master cylinder to the clutch.

• Raw Material: mainly PP
• Smooth straight or bent tubes answering to routing requirements
• Equipped with protection solution if needed

Water draining tubes

These tubes ensure evacuation of potential water outside of the air filters.

• Raw Material: mainly PP, PA6, PA12
• Mostly corrugated bent tubes to answer to routing requirements
• End cuffs designed on demand to fit with air filter interfaces
• Equipped with protection and fastening solution if needed

Battery draining tubes

These tubes ensure the evacuation of potential electrolyte waste from battery to the bottom of the car.

• Raw Material: PP
• Mostly corrugated bent tubes to answer to routing requirements
• End cuffs designed on demand to fit with battery interfaces
• Equipped with protection and fastening solution if needed

Canister purge lines

These lines allow to collect gasoline vapors to redirect them to the air intake manifold

• Raw Material: Particularly PA12/PA9T, Multilayers based on PVDF or EVOH…
• Mostly smooth bent tubes to answer to routing requirements
• Delivered with specific connectors (Quick Connectors); and fastening and protection solutions if needed
• Equipped with purge and diagnostic valves if needed

Cooling and Ventilation Air tube

These tubes allow to cool down and vent, through supply of fresh air, several systems within engine environment and passenger compartment (glove box, battery…)

• Raw Material: mainly PP
• Mostly corrugated bent tubes to answer to routing requirements
• Cuff end design adjusted to the system’s interfaces, through specific shapes coming from extrusion and/or injection process
• Equipped with protection and fastening solution if needed